External Wiring
● Please turn off the power before wiring.
● Please close the lid after wiring.
● Please select professional personnel to check and wire the system.
● Please don't destroy the wire or put heavy things on the wire.
● Please select the specified voltage.
● Please install ground wire.
● Please use specified binding post.
● Please make sure to use insulation in binding post.
1) Please follow the circuit topography to connect external devices (such as polymeric flocculation dosing pump, ferrous sulfate dosing pump, sludge feed pump) to the binding post.
2) Please install ground wire for external devices.
3) Please confirm the parts which are connected to binding post.
| Binding post specification | BNH15W | BNH30W | BNH40W |
| Wire specification | 2.0mm² | 5.5mm² | 8.0mm² |
| Screw specification | M3 | M4 | M5 |
● Please turn off operation board power and external power before wiring.
● Please close the lid after wiring.
● Please select professional personnel to check and wire the system.
● Please don't destroy the wire or put heavy things on the wire.
● Please don't use beyond specified power capacity for external signals.
● Please don't use beyond specified voltage capacity for external signals.
● Please use specified binding post.
● Please make sure to use insulation in binding post.
1) Please use specified binding post to connect external signals according to the circuit topography.
2) Please refer to below table of specification for binding post.
3) External signal output power contact capacity is as follows.
4) External signal input power contact capacity is as follows.
For more information or enquiry, please contact Environmech Sdn. Bhd.
Contact us: http://www.environmech.com/p/contact-us.html
Website: www.Environmech.com
