Dirt Collector Removal & Installation (Figure 6)
1. Close the inlet and the outlet line valves.
2. Set the main switch at the control panel to "0" position.
3. Verify that the filter is drained prior to service.
4. Remove the nuts and washers attaching the cover to the filter housing.
5. Remove the "victaulic" coupling of the rear service opening cover to the filter housing.
6. Pull the coarse screen out of the fine screen assembly.
7. Pull the fine screen assembly out of the filter housing assembly.
8. Through the spiral guide housing openings pull the split pin and the fixed pin from the dirt
collector connecting axis.
9. Remove the defective dirt collector out of the filter housing assembly.
10. Install the new dirt collector into the filter housing assembly.
11. Through the sprinkler opening install the nut and washer attaching the connecting axis to
the dirt collector.
12. Insert the pins previously removed in step 9.
13. Slide the fine screen assembly into the filter housing assembly verify that the dirt
collector axis is in the screen bearing, located in the screen handle).
14. Slide the coarse screen into the fine screen assembly.
15. Install the "victaulic" coupling of the rear service opening cover to the filter housing.
16. Verify that the straight side of the body seal fits into the groove located in the cover.
17. Install the nuts and washers attaching the cover to the filter housing.
18. Set the main switch at the control panel to "1" position.
19. Open the inlet and outlet line valves.
3. Verify that the filter is drained prior to service.
4. Remove the nuts and washers attaching the cover to the filter housing.
5. Remove the "victaulic" coupling of the rear service opening cover to the filter housing.
6. Pull the coarse screen out of the fine screen assembly.
7. Pull the fine screen assembly out of the filter housing assembly.
8. Through the spiral guide housing openings pull the split pin and the fixed pin from the dirt
collector connecting axis.
9. Remove the defective dirt collector out of the filter housing assembly.
10. Install the new dirt collector into the filter housing assembly.
11. Through the sprinkler opening install the nut and washer attaching the connecting axis to
the dirt collector.
12. Insert the pins previously removed in step 9.
13. Slide the fine screen assembly into the filter housing assembly verify that the dirt
collector axis is in the screen bearing, located in the screen handle).
14. Slide the coarse screen into the fine screen assembly.
15. Install the "victaulic" coupling of the rear service opening cover to the filter housing.
16. Verify that the straight side of the body seal fits into the groove located in the cover.
17. Install the nuts and washers attaching the cover to the filter housing.
18. Set the main switch at the control panel to "1" position.
19. Open the inlet and outlet line valves.
WARNING
Take precaution while operating the filter as the filter may enter a CLEANING
mode automatically, without prior warning.
Take precaution while operating the filter as the filter may enter a CLEANING
mode automatically, without prior warning.
20. Perform a CLEANING cycle by pressing the MANUAL FLUSH switch at the control
panel.
21. Verify that the hydraulic CLEANING valves close after 5 CLEANING cycles and
CLEANING lamp at the control panel extinguishes.
22. Check for leaks.
panel.
21. Verify that the hydraulic CLEANING valves close after 5 CLEANING cycles and
CLEANING lamp at the control panel extinguishes.
22. Check for leaks.
For more information or enquiry, please contact Environmech Sdn. Bhd.
Contact us: http://www.environmech.com/p/contact-us.html
Website: www.Environmech.com
