Fine Screen Assembly Removal & Installation (Figure 5)
17. Perform a CLEANING cycle by pressing the MANUAL FLUSH switch at the control panel.
18. Verify that the hydraulic CLEANING valves close after 5 CLEANING cycle and CLEANING
1. Close the inlet and the outlet line valves.
2. Set the main switch at the control panel to "0" position.
3. Verify that the filter is drained prior to service.
4. Remove the nuts and washers attaching the cover to the filter housing.
5. Remove the body seal from the cover groove.
6. Pull the coarse screen out of the fine screen assembly.
2. Set the main switch at the control panel to "0" position.
3. Verify that the filter is drained prior to service.
4. Remove the nuts and washers attaching the cover to the filter housing.
5. Remove the body seal from the cover groove.
6. Pull the coarse screen out of the fine screen assembly.
7. Pull the fine screen assembly out of the filter housing assembly (On 6" filters and above,
the coarse screen is screwed into the fine screen assembly).
8. Remove the seals from the old fine screen assembly.
9. Position both upper and lower seals into the new fine screen assembly.
10. Lubricate upper and lower seals with silicone grease.
11. Slide the new fine screen assembly into the filter housing assembly (verify that the dirt
collector axis is in the screen bearing, located in the screen handle).
12. Slide the coarse screen into the fine screen assembly.
13. Verify that the straight side of the body seal fits into the groove located in the cover.
14. Install the nuts and washers attaching the cover to the filter housing.
15. Set the main switch at the control panel to "1" position.
16. Open the inlet and outlet line valves.
WARNING
Take precaution while operating the filter as the filter may enter a CLEANING
mode automatically, without prior warning.
the coarse screen is screwed into the fine screen assembly).
8. Remove the seals from the old fine screen assembly.
9. Position both upper and lower seals into the new fine screen assembly.
10. Lubricate upper and lower seals with silicone grease.
11. Slide the new fine screen assembly into the filter housing assembly (verify that the dirt
collector axis is in the screen bearing, located in the screen handle).
12. Slide the coarse screen into the fine screen assembly.
13. Verify that the straight side of the body seal fits into the groove located in the cover.
14. Install the nuts and washers attaching the cover to the filter housing.
15. Set the main switch at the control panel to "1" position.
16. Open the inlet and outlet line valves.
WARNING
Take precaution while operating the filter as the filter may enter a CLEANING
mode automatically, without prior warning.
17. Perform a CLEANING cycle by pressing the MANUAL FLUSH switch at the control panel.
18. Verify that the hydraulic CLEANING valves close after 5 CLEANING cycle and CLEANING
lamp at the control panel extinguishes.
19. Check for leaks.
19. Check for leaks.
For more information or enquiry, please contact Environmech Sdn. Bhd.
Contact us: http://www.environmech.com/p/contact-us.html